So, I couldn't figure out why I was getting the magic smoke on my last board. Turns out that I had an extra board just in case and I had even ordered a duplicate set of parts (just in case). So I decided to solder this extra board instead and just use the Arduino. This was a lot easier and made me wonder why I didn't attempt this in the first place. I guess I just wanted to try my hand at surface mount soldering!
After plugging it into the dexter board, I was able to verify that the hardware was working perfectly! My surface mount soldering skills are climbing :) Now, I "just" need to write the software.
No comments:
Post a Comment